NetHunter Bluetooth-Arsenal
Bluetooth-Arsenal is the control centre for Bluetooth based attacks.
Start Bluetooth Arsenal
Click on the hamburger menu item and select âBluetooth Arsenalâ to open the Bluetooth menu. Here you can start & stop the services, enable the interfaces, and scan for discoverable devices. Note that devices can be also found which is not in discovery mode, using the Redfang in the next page. BLE is not supported yet.
Only first run: Tap on âCheck and installâ on the welcome popup to install dependencies. If you need to setup or update in the future, use the options menu at any time on the top right corner.
Main Menu
Connect your bluetooth adapter(s) via OTG if you havenât done so, and press the refresh icon to have them in the spinner menu. Enable dbus, bluetooth services, and bring up the adapter (hci0) using the switches. If you select a second adapter (hci1), tap refresh again, and bring up that one too with the interface switch. Select the required interface for scanning in the spinner. Enter your scan time if 10 seconds is not ideal. You are ready to scan, press âSCAN FOR DEVICESâ. If any found, tap on it, so it will be selected for later usage.
Enter your interface name, if your use multiple adapters. You can paste the selected target address by tapping on the âUSE SELECTED TARGETâ.
L2ping
Ideal for crashing targetâs bluetooth stack, so the connected device(s) may get disconnected, available for discovery or attacks. Modify the size, or count if needed. Flood ping also boosts up the possibility to disconnect paired devices. Reverse ping sends echo response instead of echo request.
Redfang
Use to find devices which are not in pairing mode. Enter the target range, and modify the logfile path if needed. Tap on âHUNT FOR DEVICESâ to start.
Blueranger
See how close the target is. Tap on âCHECK PROXIMITYâ to start.
SDPtool
Look at the targetâs services to find open ones. Handsfree service is our vulnerable audio service. Tap on âDISCOVER SERVICESâ to start.
Spoof
Enter your interface name, if your use multiple adapters. You can paste the selected targetâs address, name, and class by tapping on the âUSE SELECTED TARGETâ, otherwise enter the desired modifications.
Tap on âAPPLYâ to set. You can also verify by tapping on âCHECKâ.
Carwhisperer
Enter your interface name, if your use multiple adapters. You can paste the selected target address by tapping on the âUSE SELECTED TARGETâ.
Modify the channel, if the targetâs Handsfree service is on a different one. Select the mode:
Listen
Will start recording the audio from the targetâs microphone. Modify the record filename if needed.
Inject
Will inject the selected audio to the target, so it will be played on itâs speaker. Enter or select the audio fileâs path to inject.
Tapping on âLAUNCHâ starts the script in the terminal. You can kill in the terminal with CTRL+C or in the app by tapping on âKILLâ. Play button starts to stream live on your speaker if listening is running, otherwise it will play the last recording. Please note that the Stop button will stop the playback, pause is not supported.
Last updated
Was this helpful?